Rainbow-electronics ATmega128L Manual de usuario descargar pdf (Pagina 55)

ATmega128(L)

2467B–09/01

Notes: 1. When the BOOTRST fuse is programmed, the device will jump to the Boot Loader

address at reset, see “Boot Loader Support – Read-While-Write Self-Programming”

on page 266.

2. When the IVSEL bit in MCUCR is set, interrupt vectors will be moved to the start of

the boot flash section. The address of each interrupt vector will then be address in

this table added to the start address of the boot Flash section.

3. The Interrupts on address $0030 - $0044 do not exist in ATmega103 compatibility

mode.

Table 24 shows reset and interrupt vectors placement for the various combinations of

BOOTRST and IVSEL settings. If the program never enables an interrupt source, the

interrupt vectors are not used, and regular program code can be placed at these loca-

tions. This is also the case if the Reset Vector is in the Application section while the

interrupt vectors are in the boot section or vice versa.

Note: The Boot Reset Address is shown in Table 113 on page 277. For the BOOTRST fuse “1”

means unprogrammed while “0” means programmed.

31 $003C

(3)

USART1, RX USART1, Rx Complete

32 $003E

(3)

USART1, UDRE USART1 Data Register Empty

33 $0040

(3)

USART1, TX USART1, Tx Complete

34 $0042

(3)

TWI 2-wire Serial Interface

35 $0044

(3)

SPM READY Store Program Memory Ready

Table 24. Reset and Interrupt Vectors Placement

BOOTRST IVSEL Reset address Interrupt Vectors Start Address

1 0 $0000 $0002

1 1 $0000 Boot Reset Address + $0002

0 0 Boot Reset Address $0002

0 1 Boot Reset Address Boot Reset Address + $0002

Table 23. Reset and Interrupt Vectors (Continued)

Vector

No.

Program

Address

(2)

Source Interrupt Definition

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 330 331

Comentarios a estos manuales

Sin comentarios

Rainbow-electronics ATmega128L Manual de usuario Pagina 55

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Rainbow-electronics ATmega128L