Rainbow-electronics ATmega32L Manual de usuario descargar pdf (Pagina 245)

245

ATmega32(L)

2503C–AVR–10/02

Note: 1. “1” means unprogrammed, “0” means programmed

Entering the Boot Loader

Program

Entering the Boot Loader takes place by a jump or call from the application program.

This may be initiated by a trigger such as a command received via USART, or SPI inter-

face. Alternatively, the Boot Reset Fuse can be programmed so that the Reset Vector is

pointing to the Boot Flash start address after a reset. In this case, the Boot Loader is

started after a reset. After the application code is loaded, the program can start execut-

ing the application code. Note that the fuses cannot be changed by the MCU itself. This

means that once the Boot Reset Fuse is programmed, the Reset Vector will always

point to the Boot Loader Reset and the fuse can only be changed through the serial or

parallel programming interface.

Table 96. Boot Lock Bit0 Protection Modes (Application Section)

(1)

BLB0 Mode BLB02 BLB01 Protection

111

No restrictions for SPM or LPM accessing the Application

section.

2 1 0 SPM is not allowed to write to the Application section.

300

SPM is not allowed to write to the Application section, and

LPM executing from the Boot Loader section is not

allowed to read from the Application section. If interrupt

vectors are placed in the Boot Loader section, interrupts

are disabled while executing from the Application section.

401

LPM executing from the Boot Loader section is not

allowed to read from the Application section. If interrupt

vectors are placed in the Boot Loader section, interrupts

are disabled while executing from the Application section.

Table 97. Boot Lock Bit1 Protection Modes (Boot Loader Section)

(1)

BLB1 mode BLB12 BLB11 Protection

111

No restrictions for SPM or LPM accessing the Boot Loader

section.

2 1 0 SPM is not allowed to write to the Boot Loader section.

300

SPM is not allowed to write to the Boot Loader section,

and LPM executing from the Application section is not

allowed to read from the Boot Loader section. If interrupt

vectors are placed in the Application section, interrupts

are disabled while executing from the Boot Loader

section.

401

LPM executing from the Application section is not allowed

to read from the Boot Loader section. If interrupt vectors

are placed in the Application section, interrupts are

disabled while executing from the Boot Loader section.

1 2 ... 240 241 242 243 244 245 246 247 248 249 250 ... 312 313

Comentarios a estos manuales

Sin comentarios

Rainbow-electronics ATmega32L Manual de usuario Pagina 245

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Rainbow-electronics ATmega32L