Rainbow-electronics GM862-QUAD-PY Manual de usuario Pagina 23
- Pagina / 434
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 23 of 434
3.4 AT Commands Availability Table
The following table lists the AT commands set and matches the availability of every single command
versus the Telit wireless module family. It deals with backward compatibility issues too, showing the
availability of every single command depending on selected interface style (#SELINT).
COMMAND
GM862
-
QUAD
GM862-
QUAD-
PY
GM862-
GPS
GE863-
QUAD
&GE863-
PRO
3
GE863-
PY &
GE863-
SIM
GE863-
GPS
GE864-
AUTO
GE864-
QUAD
&
GC864-
QUAD
GC864-
PY
&
GE864-
PY
Function
Page
Command Line General Format - Command Line Prefixes
AT
• • • • • • • • •
Starting A Command Line 31
A/
• • • • • • • • •
Last Command Automatic Repetition Prefix 31
General Configuration Commands - AT Interface Backward Compatibility
#SELINT
• • •
•
12
• •
• •
Select Interface Style 33
Hayes AT Commands - Generic Modem Control
&F
• • • • • • • • •
Set To Factory-Defined Configuration 34
Z
• • • • • • • • •
Soft Reset 34
+FCLASS
• • • • • • • • •
Select Active Service Class 34
&Y
• • • • • • • • •
Designate A Default Reset Basic Profile 35
&P
• • • • • • • • •
Designate A Default Reset Full Profile 35
&W
• • • • • • • • •
Store Current Configuration 36
&Z
• • • • • • • • •
Store Telephone Number In The Module
Internal Phonebook
36
&N
• • • • • • • • •
Display Internal Phonebook Stored Numbers 36
+GMI
• • • • • • • • •
Manufacturer Identification 36
+GMM
• • • • • • • • •
Model Identification 37
+GMR
• • • • • • • • •
Revision Identification 37
+GCAP
• • • • • • • • •
Capabilities List 37
+GSN
• • • • • • • • •
Serial Number 37
&V
• • • • • • • • •
Display Current Base Configuration And
Profile
37
&V0
• • • • • • • • •
Display Current Configuration And Profile 38
&V1
• • • • • • • • •
S Registers Display 38
&V3
• • • • • • • • •
Extended S Registers Display 38
&V2
• • • • • • • • •
Display Last Connection Statistics 39
\V
• • • • • • • • •
Single Line Connect Message 39
+GCI
• • • • • • • • •
Country Of Installation 39
%L
• • • • • • • • •
Line Signal Level 39
%Q
• • • • • • • • •
Line Quality 40
L
• • • • • • • • •
Speaker Loudness 40
M
• • • • • • • • •
Speaker Mode 40
Hayes AT Commands - DTE-Modem Interface Control
E
• • • • • • • • •
Command Echo 40
Q
• • • • • • • • •
Quiet Result Codes 40
V
• • • • • • • • •
Response Format 41
X
• • • • • • • • •
Extended Result Codes 42
I
• • • • • • • • •
Identification Information 43
&C
• • • • • • • • •
Data Carrier Detect (DCD) Control 43
&D
• • • • • • • • •
Data Terminal Ready (DTR) Control 43
\Q
• • • • • • • • •
Standard Flow Control 45
12
GE863-PRO3 does not support selint command
- AT Commands Reference Guide 1
- SW Version 2
- 7.03.00 / 7.02.05 2
- Contents 3
- DISCLAIMER 5
- 1 INTRODUCTION 6
- 2 APPLICABLE DOCUMENTS 7
- 3 AT COMMANDS 8
- 3.2 AT Command Syntax 9
- 3.2.1 String Type Parameters 10
- 3.2.2 Command Lines 10
- Valid for SELINT 0,1 only 15
- (context activation + DNS 17
- 3.2.5 Command Issuing Timing 19
- 3.3 Storage 20
- Valid for #SELINT=2 only 22
- 3.5 AT Commands References 31
- 3.5.3.1.2 Soft Reset - Z 34
- 3.5.3.1.24 Speaker Mode - M 40
- 3.5.3.2.1 Command Echo - E 40
- 3.5.3.3 Call Control 50
- 3.5.3.3.2 Tone Dial - T 54
- 3.5.3.3.3 Pulse Dial - P 55
- 3.5.3.3.4 Answer - A 55
- 3.5.3.3.5 Disconnect - H 55
- 3.5.3.4 Modulation Control 56
- 3.5.3.5 Compression Control 57
- 3.5.3.6 Break Control 58
- 3.5.3.7 S Parameters 59
- 3.5.3.7.2 Ring Counter - S1 60
- 3.5.4.1 General 68
- 3.5.4.2 Call Control 71
- ATD03282131321; 112
- 3.5.4.4.3 Enter PIN - +CPIN 114
- #SHDN #CSURVUC +CREG $GPSWK 120
- #WAKE #CSURVB +COPS $GPSSAV 120
- #GPIO #CSURVF +CPAS $GPSCON 120
- #ADC +CFUN $GPSPRG 120
- 3.5.4.6 Voice Control 148
- 3.5.4.7 Commands For GPRS 150
- Scheme 178
- 3.5.6.1.2 Model ID - +FMM 233
- 3.5.6.3 Serial Port Control 236
- 3.5.7 Custom AT Commands 238
- - (G-L): User Defined Tones 247
- AT#PSAV 296
- 3.5.7.3.2 Socket Info - #SI 316
- 3.5.7.3.7 Socket Dial - #SD 321
- 3.5.7.4 FTP AT Commands 326
- 3.5.7.4.4 FTP Put - #FTPPUT 327
- 3.5.7.4.5 FTP Get - #FTPGET 328
- 3.5.7.5.8 Query DNS - #QDNS 341
- #CSURVUC 388
- #CSURVNLF 392
- Interpreter, AT Commands 409
- 3.5.7.10.8 Reboot - #REBOOT 417
- 4 List of acronyms 431
- 5 Document Change Log 433
Relacionado con productos y manuales para Receptor Gps Rainbow-electronics GM862-QUAD-PY
(2 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.056 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales