Rainbow-electronics ATmega128RFA1 Manual de usuario descargar pdf (Pagina 92)

8266A-MCU Wireless-12/09

ATmega128RFA1

Protection prevents that a new valid frame passes to the Frame Buffer until the buffer

protection bit is cleared (RX_SAFE_MODE = 0).

A received frame is automatically protected against overwriting:

• in Basic Operating Mode, if its FCS is valid

• in Extended Operating Mode, if an TRX24_RX_END interrupt is generated

The Dynamic Frame Buffer Protection is enabled, if register bit RX_SAFE_MODE

(register TRX_CTRL_2, see

"TRX_CTRL_2 – Transceiver Control Register 2" on page

112) is set and the radio transceiver state is RX_ON or RX_AACK_ON.

Note that Dynamic Frame Buffer Protection only prevents write accesses from the air

interface not from the application software. The application software may still modify the

Frame Buffer content.

9.8.8 Security Module (AES)

The security module (AES) is characterized by:

• Hardware accelerated encryption and decryption;

• Compatible with AES-128 standard (128 bit key and data block size);

• ECB (encryption/decryption) mode and CBC (encryption) mode support;

• Stand-alone operation, independent of other blocks;

See TBD Application regarding the AES security module usage.

9.8.8.1 Overview

The security module is based on an AES-128 core according to the FIPS197 standard

[5]. and provides two modes, the Electronic Code Book (ECB) and the Cipher Block

Chaining (CBC). The security module works independent of other building blocks of the

radio transceiver. Encryption and decryption can be performed in parallel to a frame

transmission or reception.

The ECB and CBC modules including the AES core are clocked with the 16 MHz Radio

Transceiver Crystal Oscillator.

Controlling the security block is possible over 5 Registers within AVR I/O space:

Table 9-24. Security Module Address Space Overview

AES_STATUS AES status register

AES_CTRL AES control register

AES_KEY Access to 16 Byte key buffer

AES_STATE Access to 16 Byte data buffer

9.8.8.2 Security Module Preparation

The use of the security module requires a configuration of the security engine before

starting a security operation. The following steps are required:

Table 9-25. AES Engine Configuration Steps

Step Description Description

1 Key Setup Write encryption or decryption key to KEY

buffer

(16 consecutive byte writes to AES_KEY)

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 523 524

Comentarios a estos manuales

Sin comentarios

Rainbow-electronics ATmega128RFA1 Manual de usuario Pagina 92

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Rainbow-electronics ATmega128RFA1