Rainbow-electronics AT24C16A Manual de usuario descargar pdf (Pagina 6)

AT24C02A/04A/08A/16A

0976D–12/01

Device Operation CLOCK and DATA TRANSITIONS: The SDA pin is normally pulled high with an exter-

nal device. Data on the SDA pin may change only during SCL low time periods (refer to

Data Validity timing diagram). Data changes during SCL high periods will indicate a start

or stop condition as defined below.

START CONDITION: A high-to-low transition of SDA with SCL high is a start condition

which must precede any other command (refer to Start and Stop Definition timing

diagram).

STOP CONDITION: A low-to-high transition of SDA with SCL high is a stop condition.

After a read sequence, the stop command will place the EEPROM in a standby power

mode (refer to Start and Stop Definition timing diagram).

ACKNOWLEDGE: All addresses and data words are serially transmitted to and from

the EEPROM in 8 bit words

The

EEPROM sends a zero to acknowledge that it has

received each word. This happens during the ninth clock cycle.

STANDBY MODE: The AT24C02A/04A/08A/16A features a low power standby mode

which is enabled: (a) upon power-up and (b) after the receipt of the STOP bit and the

completion of any internal operations.

MEMORY RESET: After an interruption in protocol, power loss or system reset, any 2-

wire part can be reset by following these steps: (a) Clock up to 9 cycles, (b) look for SDA

high in each cycle while SCL is high and then (c) create a start condition as SDA is high.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Sin comentarios

Rainbow-electronics AT24C16A Manual de usuario Pagina 6