Note 1: Resistive loading of the N_/HP_, LP_, BP_ outputs includes the resistors used for the filter implementation.
Note 2: Crosstalk between internal filter sections is measured by applying a 1V
RMS
10kHz signal to one bandpass filter section input
and grounding the input of the other bandpass filter section. The crosstalk is the ratio between the output of the grounded
filter section and the 1V
RMS
input signal of the other section.
Note 3: Bandwidth of noise measurement is 80kHz.
Note 4: f
OSC
(kHz) = 135 x 10
3
/ C
OSC
(C
OSC
in pF)
ELECTRICAL CHARACTERISTICS—MAX7491 (continued)
(V
DD
= EXTCLK = +3V, f
CLK
= 625kHz, T
A
= T
MIN
to T
MAX
, 10kΩ || 50pF load to V
DD
/2 at LP_, BP_, and N_/HP_, SHDN = V
DD
, 0.1µF
from COM to GND, 50% duty-cycle clock input, COM = V
DD
/2. Typical values are at T
A
= +25°C, unless otherwise noted.) (Note 1)
Typical Operating Characteristics
(V
DD
= +5V for MAX7490, V
DD
= +3V for MAX7491, f
CLK
= 625kHz, SHDN = EXTCLK = V
DD
, COM = V
DD
/2, Mode 1, R3 = R1 = 50kΩ,
R2 = 10kΩ, Q = 5, T
A
= +25°C, unless otherwise noted.)
Comentarios a estos manuales