MAX194
14-Bit, 85ksps ADC with 10µA Shutdown
Spurious-Free Dynamic Range
Spurious-free dynamic range is the ratio of the funda-
mental RMS amplitude to the amplitude of the next
largest spectral component (in the frequency band
above DC and below one-half the sample rate). Usually,
this peak occurs at some harmonic of the input frequen-
cy. However, if the ADC is exceptionally linear, it may
occur only at a random peak in the ADC’s noise floor.
Transfer Function
Figures 28 and 29 show the MAX194’s transfer func-
tions. In unipolar mode, the output data is in binary for-
mat and in bipolar mode it is offset binary.
TRANSISTOR COUNT: 7966
11 . . . 111
11 . . . 110
11 . . . 101
10 . . . 010
10 . . . 001
10 . . . 000
01 . . . 111
01 . . . 110
00 . . . 010
00 . . . 001
00 . . . 000
Figure 27. Signal-to-Noise + Distortion vs. FrequencyFigure 26. Effective Bits vs. Input Frequency
Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are
implied. Maxim reserves the right to change the circuitry and specifications without notice at any time.
24
____________________Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600
© 1997 Maxim Integrated Products Printed USA is a registered trademark of Maxim Integrated Products.
Comentarios a estos manuales