Rainbow-electronics MAX1618 Manual de usuario

________________General DescriptionThe MAX1618 precise digital thermometer reports thetemperature of a remote sensor. The remote sensor is adiode-conn

above VCC- 1V (typ) or below VDXN+ 50mv (typ), afault is detected and ALERT is asserted. ADC reads+127°C. Also, if the ADC has an extremely low differ

MAX1618Remote Temperature Sensor with SMBus Serial Interface______________________________________________________________________________________ 11R

Slave AddressesThe device address can be set to one of nine differentvalues by pin-strapping ADD0 and ADD1 so more thanone MAX1618 can reside on the s

introduces errors due to the rise time of the switched-current source.PC Board Layout1) Place the MAX1618 as close as practical to theremote diode. In

MAX1618Remote Temperature Sensor with SMBus Serial Interface14 ______________________________________________________________________________________6

MAX1618Remote Temperature Sensor with SMBus Serial Interface______________________________________________________________________________________ 15/

MAX1618Remote Temperature Sensor with SMBus Serial Interface16 ______________________________________________________________________________________i

MAX1618Remote Temperature Sensor with SMBus Serial Interface______________________________________________________________________________________ 17i

MAX1618Remote Temperature Sensor with SMBus Serial InterfaceMaxim cannot assume responsibility for use of any circuitry other than circuitry entirely

Autoconvertmode, averageMAX1618Remote Temperature Sensor with SMBus Serial Interface2 ________________________________________________________________

MAX1618Remote Temperature Sensor with SMBus Serial Interface_______________________________________________________________________________________ 3E

40-401 100TEMPERATURE ERRORvs. LEAKAGE RESISTANCE-20-30-100102030MAX1618 toc01LEAKAGE RESISTANCE (MΩ)TEMPERATURE ERROR (°C)10PATH = DXP TO GND AND CON

MAX1618Remote Temperature Sensor with SMBus Serial Interface_______________________________________________________________________________________ 51

MAX1618Remote Temperature Sensor with SMBus Serial Interface6 _______________________________________________________________________________________P

MAX1618Remote Temperature Sensor with SMBus Serial Interface_______________________________________________________________________________________ 7F

Low-Power Standby ModeStandby mode disables the ADC and reduces the sup-ply-current drain to 3µA (typ). Enter standby mode byforcing the STBY pin low

and does not go inactive until the temperature dropsbelow TLOW. Enable thermostat mode through the configuration reg-ister (Table 4), with one bit to