Rainbow-electronics MAX1183 Manual de usuario

General DescriptionThe MAX1183 is a +3V, dual 10-bit analog-to-digitalconverter (ADC) featuring fully differential widebandtrack-and-hold (T/H) inputs

MAX1183Detailed DescriptionThe MAX1183 uses a nine-stage, fully differential,pipelined architecture (Figure 1) that allows for high-speed conversion w

Input Track-and-Hold (T/H) CircuitsFigure 2 displays a simplified functional diagram of theinput track-and-hold (T/H) circuits in both track-and-hold

MAX1183SNRdB= 20 ✕ log10(1 / [2π ✕ fIN✕ tAJ])where fINrepresents the analog input frequency andtAJis the time of the aperture jitter.Clock jitter is e

Figure 4 displays the timing relationship between out-put enable and data output valid, as well as power-down/wake-up and data output valid.Power-Down

MAX1183Dual 10-Bit, 40Msps, +3V, Low-Power ADC withInternal Reference and Parallel Outputs14 _________________________________________________________

quadrature (Q) carrier component, where the Q compo-nent is 90-degree phase-shifted with respect to the in-phase component. At the receiver, the QAM s

MAX1183(1Ω to 5Ω), a ferrite bead, or a direct short.Alternatively, all ground pins could share the sameground plane, if the ground plane is sufficien

nents minus the fundamental, the first five harmonics,and the DC offset.Signal-to-Noise Plus Distortion (SINAD)SINAD is computed by taking the ratio o

MAX1183Dual 10-Bit, 40Msps, +3V, Low-Power ADC withInternal Reference and Parallel OutputsMaxim cannot assume responsibility for use of any circuitry

MAX1183Dual 10-Bit, 40Msps, +3V, Low-Power ADC withInternal Reference and Parallel Outputs2 __________________________________________________________

MAX1183Dual 10-Bit, 40Msps, +3V, Low-Power ADC withInternal Reference and Parallel Outputs____________________________________________________________

MAX1183Dual 10-Bit, 40Msps, +3V, Low-Power ADC withInternal Reference and Parallel Outputs4 __________________________________________________________

MAX1183Dual 10-Bit, 40Msps, +3V, Low-Power ADC withInternal Reference and Parallel Outputs____________________________________________________________

MAX1183Dual 10-Bit, 40Msps, +3V, Low-Power ADC withInternal Reference and Parallel Outputs6 __________________________________________________________

MAX1183Dual 10-Bit, 40Msps, +3V, Low-Power ADC withInternal Reference and Parallel Outputs____________________________________________________________

MAX1183Dual 10-Bit, 40Msps, +3V, Low-Power ADC withInternal Reference and Parallel Outputs8 __________________________________________________________

MAX1183Dual 10-Bit, 40Msps, +3V, Low-Power ADC withInternal Reference and Parallel Outputs____________________________________________________________