Rainbow-electronics ATtiny43U Manual de usuario descargar pdf (Pagina 47)

8048B–AVR–03/09

boost converter, connect pins V

BAT

and LSW to ground and provide the device with supply

directly to the V

pin.

8.11 Register Description

8.11.1 ADCSRB – ADC Control and Status Register B

• Bit 7 – BS: Boost Status

The BS bit can be used to identify silent periods of the boost converter. When this bit is one the

boost converter is active and switching, i.e. it is either in Active Regulated Mode, or in the switch-

ing period of Active Low Current Mode. When this bit is zero the boost converter is not switching,

i.e. it is either in Stop Mode or in the non-switching period of Active Low Current Mode.

Alternatively, the BS bit can be programmed to return the state of the duty cycle controller, as

follows:

1. Write 11xx xxxx to register PRR

2. Within 3 clock cycles of the above, write 10xx xxxx to register PRR

3. Wait (issue a single-cycle no operation)

4. Within 5 clock cycles of first write, read the BS bit

If the BS bit now is zero the converter is operating in normal duty cycle control mode. If the bit is

one the converter is working in full duty cycle mode.

Bit 7 6543210

0x03 (0x23) BS

ACME – ADLAR – ADTS2 ADTS1 ADTS0 ADCSRB

Read/Write R R/W R/W R/W R/W R/W R/W R/W

Initial Value 00000000

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 181 182

Sin comentarios

Rainbow-electronics ATtiny43U Manual de usuario Pagina 47