Rainbow-electronics MAX7311 Manual de usuario descargar pdf (Pagina 9)

Eight of the MAX7311’s nine registers are configured to

operate as four register pairs: input ports, output ports,

polarity inversion ports, and configuration ports. After

sending 1 byte of data to one register, the next byte is

sent to the other register in the pair. For example, if the

first byte of data is sent to output port 2, then the next

byte of data is stored in output port 1. An unlimited

number of data bytes can be sent in one write transmis-

sion. This allows each 8-bit register to be updated inde-

pendently of the other registers.

Reading Port Registers

To read the device data, the bus master must first send

the MAX7311 address with the R/W bit set to zero, fol-

lowed by the command byte, which determines which

must then send the MAX7311 address with the R/W bit

set to 1. Data from the register defined by the com-

mand byte is then sent from the MAX7311 to the master

(Figures 8, 9).

MAX7311

2-Wire-Interfaced 16-Bit I/O Port Expander

with Interrupt

_______________________________________________________________________________________ 9

S 0 A A S 1 A A NA P

SLAVE ADDRESS SLAVE ADDRESS MSB DATA LSB MSB DATA LSBCOMMAND BYTE

R/W

ACKNOWLEDGE

FROM SLAVE

ACKNOWLEDGE

FROM SLAVE

ACKNOWLEDGE

FROM SLAVE

MASTER TRANSMITTER BECOMES

MASTER RECEIVER AND SLAVE

RECEIVER BECOMES SLAVE TRANSMITTER

DATA FROM LOWER OR

UPPER BYTE OF REGISTER

DATA FROM LOWER OR

UPPER BYTE OF REGISTER

TRANSFER OF DATA CAN BE STOPPED AT ANY TIME BY A STOP CONDITION.

Figure 8. Read from Register

123456789

SCL

SLAVE ADDRESS PORT 1 DATA PORT 2 DATA PORT 1 DATA PORT 2 DATAS1777700001PA A A A

R/W

ACKNOWLEDGE

FROM SLAVE

ACKNOWLEDGE

FROM MASTER

ACKNOWLEDGE

FROM MASTER

ACKNOWLEDGE

FROM MASTER

NONACKNOWLEDGE

FROM MASTER

READ FROM PORT 1

READ FROM PORT 2

DATA INTO PORT 1

DATA INTO PORT 2

INT

TRANSFER OF DATA CAN BE STOPPED ANYTIME BY A STOP CONDITION. WHEN THE

STOP CONDITION OCCURS, DATA PRESENT AT THE LAST ACKNOWLEDGE PHASE IS

VALID (OUTPUT MODE) AND COMMAND BYTE HAS PREVIOUSLY BEEN SET TO REGISTER 00.

Figure 9. Read from Input Registers

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Comentarios a estos manuales

Sin comentarios

Rainbow-electronics MAX7311 Manual de usuario Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Panel De Control Rainbow-electronics MAX7311