Rainbow-electronics DS3904 Manual de usuario Pagina 11

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 11
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 10
DS3904
DS3904 Triple 128-Position Nonvolatile
Variable Digital Resistor/Switch
Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are
implied. Maxim reserves the right to change the circuitry and specifications without notice at any time.
Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600 ____________________ 11
© 2003 Maxim Integrated Products Printed USA is a registered trademark of Maxim Integrated Products.
Following the start condition, the DS3904 monitors the
SDA bus checking the device-type identifier being
transmitted. Upon receiving the 101000 control code,
the appropriate device address bit, and the read/write
bit, the slave device outputs an acknowledge signal on
the SDA line.
Applications Information
Power-Supply Decoupling
To achieve the best results when using the DS3904,
decouple the power supply with a 0.01µF or 0.1µF
capacitor. Use a high-quality ceramic surface-mount
capacitor. Surface-mount components minimize lead
inductance, which improves performance, and ceramic
capacitors tend to have adequate high-frequency
response for decoupling applications.
Using the Resistor as a Switch
By taking advantage of the high-impedance mode, a
switch can be created to produce a digital output.
Setting one of the resistor registers to 00h creates the
low state. Writing 80h into the same resistor register
enables the high-impedance state. Furthermore, an
external pullup resistor can be used to generate a high
state as well.
High Resistor Terminal Voltage
It is possible to have a voltage on the resistor-high termi-
nals that is higher than the voltage connected to V
CC
.
For instance, connecting V
CC
to 3.0V while one or more
of the resistor high terminals are connected to 5.0V
allows a 3V system to control a 5V system. The 5.5V
maximum still applies to the limit on the resistor high ter-
minals regardless of the voltage present on V
CC
.
Chip Information
TRANSISTOR COUNT: 9049
SUBSTRATE CONNECTED TO GROUND
Package Information
For the latest package outline information, go to www.maxim-ic.
com/packages.
Vista de pagina 10
1 2 ... 6 7 8 9 10 11

Comentarios a estos manuales

Sin comentarios