Rainbow-electronics DS1384 Manual de usuario descargar pdf (Pagina 9)

DS1384

9 of 17

TIME OF DAY ALARM REGISTERS

Registers 3, 5, and 7 contain the time of day alarm registers. Bits 3, 4, 5, and 6 of register 7 will always

read 0 regardless of how they are written. Bit 7 of registers 3, 5, and 7 are mask bits (Figure 3). When all

of the mask bits are logic 0, a time of day alarm will only occur when registers 2, 4, and 6 match the

values stored in registers 3, 5, and 7. An alarm will be generated every day when bit 7 of register 7 is set

to a logic 1. Similarly, an alarm is generated every hour when bit 7 of registers 7 and 5 is set to a logic 1.

When bit 7 of registers 7, 5, and 3 is set to a logic 1, an alarm will occur every minute when register 1

(seconds) rolls from 59 to 00.

Time of day alarm registers are written and read in the same format as the time of day registers. The time

of day alarm flag and interrupt is always cleared when alarm registers are read or written.

WATCHDOG ALARM REGISTERS

Registers C and D contain the time for the Watchdog Alarm. The two registers contain a time count from

00.01 to 99.99 seconds in BCD. The value written into the Watchdog Alarm Registers can be written or

read in any order. Any access to Register C or D will cause the Watchdog Alarm to reinitialize and clears

the Watchdog Flag Bit and the Watchdog Interrupt Output. When a new value is entered or the Watchdog

Registers are read, the Watchdog Timer will start counting down from the entered value to 0. When 0 is

reached, the Watchdog Interrupt Output will go to the active state. The Watchdog Timer Countdown is

interrupted and reinitialized back to the entered value every time either of the registers are accessed. In

this manner, controlled periodic accesses to the Watchdog Timer can prevent the Watchdog Alarm from

ever going to an active level. If access does not occur, countdown alarm will be repetitive. The

Watchdog Alarm Registers always read the entered value. The actual count down register is internal and

is not readable. Writing registers C and D to 0 will disable the Watchdog Alarm feature.

COMMAND REGISTER

Address location 0Bh is the Command Register where mask bits, control bits and flag bits reside. The

operation of each bit is as follows:

TE - Bit 7 Transfer enable - This bit when set to a logic 0 will disable the transfer of data between

internal and external clock registers. The contents in the external clock registers are now frozen and reads

or writes will not be affected with updates. This bit must be set to a logic 1 to allow updates.

IPSW - Bit 6 Interrupt switch - When set to a logic 1,

INTA is the Time of Day Alarm and INTB /(INTB)

is the Watchdog Alarm. When set to logic 0, this bit reverses the output pins.

INTA is now the Watchdog

Alarm output and INTB /(INTB) is the Time of Day Alarm output.

IBH/LO - Bit 5 Interrupt B Sink or Source Current -When this bit is set to a logic 1 and V

is applied,

INTB /(INTB) will source current (see DC characteristics I

). When this bit is set to a logic 0, INTB will

sink current (see DC characteristics I

PU/LVL - Bit 4 Interrupt pulse mode or level mode - This bit determines whether both interrupts will

output a pulse or level signal. When set to a logic 0, INTA and INTB /(INTB) will be in the level mode.

When this bit is set to a logic 1, the pulse mode is selected and INTA will sink current for a minimum of

3 ms and then release. INTB /(INTB) will either sink or source current, depending on the condition of bit

5, for a minimum of 3 ms and then release.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Comentarios a estos manuales

Sin comentarios

Asus BT6130 F7737 User Manual (80 pages)

Brand: Asus | Category: PC/workstation barebones | Size: 6.54 MB |

Ordinateur de bureau ASUS

Troisième édition

Décembre 2012

Table des matières

Avis d’Industrie Canada

Déclaration de classe B VCCI

Consignes de sécurité

Contenu de la boîte

Chapitre 1

Français

Chapitre 2

Chapitre 3

Utiliser une souris

Utiliser un clavier

Chapitre 4

Chapitre 5

Chapitre 6

RJ-45 cable

Chapitre 7

Chapitre 8

ASUS BT6130

Depuis l’écran d’accueil

Depuis le Bureau

Informations de contact ASUS

More products and manuals for PC/workstation barebones Asus

Models	Document Type
M32BC 9584	User Manual ASUS M32BC 9584 User's Manual, 40 pages
M70AD G8553	User Manual ASUS M70AD G8553 User's Manual, 59 pages
M70AD TC8553	User Manual ASUS M70AD TC8553 User's Manual, 58 pages
S1	User Manual ASUS S1 User's Manual, 46 pages
M11AD DU8496	User Manual ASUS M11AD DU8496 User's Manual, 85 pages
BP7895	User Manual ASUS BP7895 User's Manual, 20 pages
D415MT 9998	User Manual ASUS D415MT 9998 User's Manual [da] , 90 pages
M32BF G9071	User Manual ASUS M32BF G9071 User's Manual, 82 pages
X205TA	User Manual ASUS X205TA User's Manual, 78 pages
M51AD R8828	User Manual ASUS M51AD R8828 User's Manual, 85 pages
UA6072	User Manual ASUS UA6072 User's Manual, 44 pages
Z97	User Manual ASUS Z97 User's Manual, 10 pages
CP6230 G8172	User Manual ASUS CP6230 G8172 User's Manual, 70 pages
RS700DA-E6/PS4 E6166	User Manual ASUS RS700DA-E6/PS4 E6166 User's Manual, 152 pages
M51AD ARB8828	User Manual ASUS M51AD ARB8828 User's Manual, 85 pages
G771JM NW9330	User Manual ASUS G771JM NW9330 User's Manual, 142 pages
K30AM-J F9380	User Manual ASUS K30AM-J F9380 User's Manual, 76 pages
BG7685	User Manual ASUS BG7685 User's Manual, 90 pages
BT6130 F6983	User Manual ASUS BT6130 F6983 User's Manual, 51 pages
T100TA	User Manual ASUS T100TA User's Manual, 100 pages