General DescriptionThe MAX8804Y/MAX8804Z intelligent, dual-input,stand-alone, constant-current, constant-voltage(CCCV), thermally regulated linear cha
MAX8804Y/MAX8804ZUSB Charge ModeDrive SET high to enable USB charging mode when theUSB input is valid. Subsequent low pulses with 1µs to1ms pulse widt
Soft-StartThe soft-start circuitry activates when entering fast-charge mode. In the MAX8804Y, soft-start is entereddirectly after being enabled, and t
MAX8804Y/MAX8804ZPower-OK Monitor (POK)The MAX8804Y/MAX8804Z contain an open-drain POKoutput that goes low when a valid input source isdetected at eit
Layout and BypassingConnect the input capacitors as close as possible tothe IC. Provide a large copper GND plane to allow theexposed paddle to sink he
MAX8804Y/MAX8804ZHigh-Voltage, Dual-Input, USB/ACAdapter Chargers in 2mm x 3mm TDFN14 ________________________________________________________________
MAX8804Y/MAX8804ZHigh-Voltage, Dual-Input, USB/ACAdapter Chargers in 2mm x 3mm TDFNMaxim cannot assume responsibility for use of any circuitry other t
MAX8804Y/MAX8804ZHigh-Voltage, Dual-Input, USB/ACAdapter Chargers in 2mm x 3mm TDFN2 _________________________________________________________________
MAX8804Y/MAX8804ZHigh-Voltage, Dual-Input, USB/ACAdapter Chargers in 2mm x 3mm TDFN___________________________________________________________________
MAX8804Y/MAX8804ZHigh-Voltage, Dual-Input, USB/ACAdapter Chargers in 2mm x 3mm TDFN4 _________________________________________________________________
MAX8804Y/MAX8804ZHigh-Voltage, Dual-Input, USB/ACAdapter Chargers in 2mm x 3mm TDFN___________________________________________________________________
MAX8804Y/MAX8804ZHigh-Voltage, Dual-Input, USB/ACAdapter Chargers in 2mm x 3mm TDFN6 _________________________________________________________________
MAX8804Y/MAX8804ZHigh-Voltage, Dual-Input, USB/ACAdapter Chargers in 2mm x 3mm TDFNDetailed DescriptionThe MAX8804Y/MAX8804Z dual-input linear battery
MAX8804Y/MAX8804ZDC ChargingThe MAX8804Y/MAX8804Z are designed to charge asingle-cell Li+ battery from a DC source voltagebetween 4.15V and 7V and wit
DC/USB Mode andCharging Current SettingSET is a logic input that sets DC/USB charging modeand charging current. Drive SET low or leave it uncon-nected
Comentarios a estos manuales