Rainbow-electronics MAX5051 Manual de usuario Pagina 1

Busca en linea o descarga Manual de usuario para Sensores Rainbow-electronics MAX5051. Rainbow Electronics MAX5051 User Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 21
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
General Description
The MAX5051 is a clamped, two-switch power-supply
controller IC. This device can be used both in forward or
flyback configurations with input voltage ranges from 11V
to 76V. It provides comprehensive protection mech-
anisms against possible faults, resulting in very high relia-
bility power supplies. When used in conjunction with sec-
ondary-side synchronous rectification, power-supply
efficiencies can easily reach 92% for a +3.3V output
power supply operated from a 48V bus. The integrated
high- and low-side gate drivers provide more than 2A of
peak gate-drive current to two external N-channel
MOSFETs. Low startup current reduces the power loss
across the bootstrap resistor. A feed-forward voltage-
mode topology provides excellent line rejection while
avoiding the pitfalls of traditional current-mode control.
The MAX5051 power-supply controller is primary as
well as secondary-side parallelable, allowing the
design of scaleable power systems when necessary.
When paralleling the primary side, dedicated pins allow
for simultaneous wakeup or shutdown of all paralleled
units, thus preventing current-hogging during startup or
fault conditions.
The MAX5051 generates a lookahead signal for driving
secondary-side synchronous MOSFETs. Special
primary-side synchronization inputs/outputs allow two
primaries to be operated 180° out of phase for increased
output power and lower input ripple currents.
The MAX5051 is available in a 28-pin TSSOP-EP
package and operates over a wide -40°C to +125°C
temperature range.
Warning: The MAX5051 is designed to work with
high voltages. Exercise caution.
Applications
High-Efficiency, Isolated Telecom/Datacom
Power Supplies
48V and 12V Server Power Supplies
48V Power-Supply Modules
42V Automotive Power Systems
Industrial Power Supplies
Features
Wide Input Voltage Range, 11V to 76V
Voltage Mode with Input Voltage Feed-Forward
Ripple-Phased Parallel Topology for High
Current/Power Output
2A Integrated High- and Low-Side MOSFET
Drivers
SYNCIN And SYNCOUT Pins Enable 180° Out-Of-
Phase Operation
Programmable Brownout and Bootstrap UVLOs
High-Side Driver Bootstrap Capacitor Precharge
Driver
Low Current-Limit Threshold for High Efficiency
Programmable Switching Frequency
Reference Voltage Soft-Start for Startup Without
Overshoots
Startup Synchronization with Multiple Paralleled
Primaries
Programmable Integrating Current-Limit Fault
Protection
Look-Ahead PWM Signal for Secondary-Side
Synchronous Rectifier Drivers
Look-Ahead Drivers for Either A High-Speed
Optocoupler or Pulse Transformer
Wide -40°C to +125°C Operating Range
Thermally Enhanced 28-Pin TSSOP Package
MAX5051
Parallelable, Clamped Two-Switch
Power-Supply Controller IC
________________________________________________________________ Maxim Integrated Products 1
Ordering Information
19-2964; Rev 0; 8/03
For pricing, delivery, and ordering information, please contact Maxim/Dallas Direct! at
1-888-629-4642, or visit Maxim’s website at www.maxim-ic.com.
EVALUATION KIT
AVAILABLE
PART TEMP RANGE PIN-PACKAGE
MAX5051AUI -40°C to +125°C 28-TSSOP-EP*
*EP = Exposed pad.
Pin Configuration appears at end of data sheet.
Vista de pagina 0
1 2 3 4 5 6 ... 20 21

Indice de contenidos

Pagina 1 - Power-Supply Controller IC

General DescriptionThe MAX5051 is a clamped, two-switch power-supplycontroller IC. This device can be used both in forward orflyback configurations wi

Pagina 2

MAX5051Parallelable, Clamped Two-Switch Power-Supply Controller IC10 _________________________________________________________________________________

Pagina 3

MAX5051Parallelable, Clamped Two-Switch Power-Supply Controller IC____________________________________________________________________________________

Pagina 4

MAX5051Detailed DescriptionThe MAX5051 controller IC is designed for two-switchforward converter power-supply topologies. It incorpo-rates an advanced

Pagina 5

If the charge stored on the boost capacitor is not ade-quately replenished then the gate-driver lockout for thehigh-side MOSFET is triggered, stopping

Pagina 6

MAX5051diode is a high-voltage, small-signal Schottky type. Itmay be helpful to connect a resistor in series with thisdiode to minimize noise as well

Pagina 7

in control. Thus, the output-voltage slew rate is constantat light or heavy loads. Once the soft-start ends, thevoltage on CSS regulates to 1.24V. Do

Pagina 8

MAX5051Normally PVIN is derived from a tertiary winding of thetransformer. However, at startup there is no energydelivered through the transformer, he

Pagina 9

Integrating Fault ProtectionThe integrating fault protection feature allows transientovercurrent conditions to be ignored for a programmableamount of

Pagina 10

MAX5051Parallelable, Clamped Two-Switch Power-Supply Controller IC18 _________________________________________________________________________________

Pagina 11

MAX5051Parallelable, Clamped Two-Switch Power-Supply Controller IC____________________________________________________________________________________

Pagina 12

MAX5051Parallelable, Clamped Two-Switch Power-Supply Controller IC2 __________________________________________________________________________________

Pagina 13

MAX5051Parallelable, Clamped Two-Switch Power-Supply Controller IC20 _________________________________________________________________________________

Pagina 14

MAX5051Parallelable, Clamped Two-Switch Power-Supply Controller ICMaxim cannot assume responsibility for use of any circuitry other than circuitry ent

Pagina 15

MAX5051Parallelable, Clamped Two-Switch Power-Supply Controller IC____________________________________________________________________________________

Pagina 16

MAX5051Parallelable, Clamped Two-Switch Power-Supply Controller IC4 __________________________________________________________________________________

Pagina 17

MAX5051Parallelable, Clamped Two-Switch Power-Supply Controller IC____________________________________________________________________________________

Pagina 18

MAX5051Parallelable, Clamped Two-Switch Power-Supply Controller IC6 __________________________________________________________________________________

Pagina 19

MAX5051Parallelable, Clamped Two-Switch Power-Supply Controller IC____________________________________________________________________________________

Pagina 20

MAX5051Parallelable, Clamped Two-Switch Power-Supply Controller IC8 __________________________________________________________________________________

Pagina 21

MAX5051Parallelable, Clamped Two-Switch Power-Supply Controller IC____________________________________________________________________________________

Comentarios a estos manuales

Sin comentarios