NAME FUNCTION
131VNEG -2.5V Charge-Pump Voltage-Output. Connect a 0.1µF capacitor to GND.
232REF-
Negative Reference Voltage Input. For internal reference operation, connect REF- to
GND. For external reference operation, bypass REF- to GND with a 0.1µF capacitor and
set V
REF-
from -2.2V to +2.2V, provided V
REF+
> V
REF-
.
31REF+
Positive Reference Voltage Input. For internal reference operation, connect a 4.7µF
capacitor from REF+ to GND. For external reference operation, bypass REF+ to GND
with a 0.1µF capacitor and set V
REF+
from -2.2V to +2.2V, provided V
REF+
> V
REF-
.
42AIN+
Positive Analog Input. Positive side of fully differential analog input. Bypass AIN+ to GND
with a 0.1µF or greater capacitor.
53AIN-
Negative Analog Input. Negative side of fully differential analog input. Bypass AIN- to
GND with a 0.1µF or greater capacitor.
64I
SET
Segment Current Controller. Connect to ground through a resistor to set the segment
current. See Table 6 for segment current selection.
75GND Ground
8—V
DD
Analog and Digital Circuit Supply Voltage. Connect V
DD
to a +2.7V to +5.25V power
supply. Bypass V
DD
to GND with a 0.1µF and a 4.7µF capacitor.
98CLK
External Clock Input. When the EXTCLK register bit is set to one, CLK is the master clock
input (frequency = 4.9152MHz) for the modulator and the filter. When the EXTCLK
register bit is reset to zero, the internal clock is used. Connect CLK to GND or DV
DD
(MAX1499) or V
DD
(MAX1497) when the internal oscillator is used.
10 9 EOC
Active-Low End-of-Conversion Logic Output. A logic low at EOC indicates that a new
ADC result is available in the ADC result register.
11 10 CS Active-Low Chip Select Input. Forcing CS low activates the serial interface.
12 11 DIN
Serial Data Input. Data present at DIN is shifted into the internal registers in response to
a rising edge at SCLK when CS is low.
13 12 SCLK
Serial Clock Input. Apply an external clock to SCLK to facilitate communication through
the serial bus. SCLK may idle high or low.
14 13 DOUT
Serial Data Output. DOUT presets serial data in response to register queries. Data shifts
out on the falling edge of SCLK. DOUT goes high impedance when CS is high.
15 14 DIG0 Digit 0 Driver
16 15 DIG1 Digit 1 Driver
17 16 GLED Ground for LED-Display Segment Driver
18 17 DIG2 Digit 2 Driver
19 18 DIG3 Digit 3 Driver
20 20 SEGA Segment A Driver
21 21 SEGB Segment B Driver
22 22 SEGC Segment C Driver
23 23 SEGD Segment D Driver
24 24 SEGE Segment E Driver
(13 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales