MAX14527/MAX14528
Adjustable Overvoltage Protector
with High Accuracy
2 _______________________________________________________________________________________
ABSOLUTE MAXIMUM RATINGS
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
(All voltages referenced to GND.)
IN ............................................................................-0.3V to +30V
OUT .............................................................-0.3V to (V
IN
+ 0.3V)
OVLO........................................................................-0.3V to +6V
Continuous IN Current .............................................................1A
Peak IN Current (Note 1)..........................................................5A
Continuous OVLO Current ...................................................50µA
Continuous Power Dissipation (T
A
= +70°C)
8-Pin TDFN (derate 11.9mW/°C above +70°C) ...........954mW
Package Junction-to-Ambient Thermal Resistance (θ
JA
)
(Note 2) .....................................................................83.9°C/W
Package Junction-to-Case Thermal Resistance (θ
JC
)
(Note 2) ........................................................................37°C/W
Operating Temperature Range ...........................-40°C to +85°C
Junction Temperature......................................................+150°C
Storage Temperature Range .............................-65°C to +150°C
Lead Temperature (soldering) .........................................+300°C
ELECTRICAL CHARACTERISTICS
(V
IN
= +2.2V to +28V, T
A
= -40°C to +85°C, unless otherwise noted. Typical values are at V
IN
= +5.0V and T
A
= +25°C.) (Note 3)
Note 1: Limited by thermal shutdown.
Note 2: Package thermal resistances were obtained using the method described in JEDEC specification JESD51-7, using a four-layer
board. For detailed information on package thermal considerations, refer to www.maxim-ic.com/thermal-tutorial
.
Note 3: All specifications are 100% production tested at T
A
= +25°C, unless otherwise noted. Specifications are over -40°C to +85°C
and are guaranteed by design.
Comentarios a estos manuales