Rainbow-electronics ADC12048 Manual de usuario

Busca en linea o descarga Manual de usuario para Sensores Rainbow-electronics ADC12048. Rainbow Electronics ADC12048 User Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 30
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
TL/H/12387
ADC12048 12-Bit Plus Sign 216 kHz 8-Channel Sampling Analog-to-Digital Converter
December 1995
ADC12048
12-Bit Plus Sign 216 kHz 8-Channel Sampling
Analog-to-Digital Converter
General Description
Operating from a single 5V power supply the ADC12048 is a
12 bit
a
sign, parallel I/O, self-calibrating, sampling analog-
to-digital converter (ADC) with an eight input fully differential
analog multiplexer. The maximum sampling rate is 216 kHz.
On request, the ADC goes through a self-calibration pro-
cess that adjusts linearity, zero and full-scale errors.
The ADC12048’s 8-channel multiplexer is software pro-
grammable to operate in a variety of combinations of single-
ended, differential, or pseudo-differential modes. The fully
differential MUX and the 12-bit
a
sign ADC allows for the
difference between two signals to be digitized.
The ADC12048 can be configured to work with many popu-
lar microprocessors/microcontrollers including National’s
HPC family, Intel386 and 8051, TMS320C25, Motorola
MC68HC11/16, Hitachi 64180 and Analog Devices
ADSP21xx.
For complementary voltage references see the LM4040,
LM4041 or LM9140.
Key Specifications (f
CLK
e
12 MHz)
Y
Resolution 12-bits
a
sign
Y
13-bit conversion time 3.6 ms, max
Y
13-bit throughput rate 216 ksamples/s, min
Y
Integral Linearity Error (ILE)
g
1 LSB, max
Y
Single Supply
a
5V
g
10%
Y
V
IN
Range GND to V
A
a
Y
Power consumption:
Normal operation 34 mW, max
Stand-by mode 75 mw, max
Features
Y
8-channel programmable Differential or Single-Ended
multiplexer
Y
Programmable Acquisition Times and user-controllable
Throughput Rates
Y
Programmable data bus width (8/13 bits)
Y
Built-in Sample-and-Hold
Y
Programmable Auto-Calibration and Auto-Zero cycles
Y
Low power standby mode
Y
No missing codes
Applications
Y
Medical instrumentation
Y
Process control systems
Y
Test equipment
Y
Data logging
Y
Inertial guidance
Block Diagram
TL/H/123871
TRI-STATE
É
is a registered trademark of National Semiconductor Corporation.
C
1996 National Semiconductor Corporation RRD-B30M26/Printed in U. S. A.
Vista de pagina 0
1 2 3 4 5 6 ... 29 30

Indice de contenidos

Pagina 1 - Analog-to-Digital Converter

TL/H/12387ADC12048 12-Bit Plus Sign 216 kHz 8-Channel Sampling Analog-to-Digital ConverterDecember 1995ADC1204812-Bit Plus Sign 216 kHz 8-Channel Samp

Pagina 2 - Ordering Information

Electrical Characteristics (Continued)TL/H/12387–9FIGURE 5a. Transfer CharacteristicTL/H/12387–10FIGURE 5b. Simplified Error vs Output Code without Au

Pagina 3

Electrical Characteristics (Continued)TL/H/12387–11FIGURE 5c. Simplified Error vs Output Code after Auto-Calibration CycleTL/H/12387–12FIGURE 6. Offse

Pagina 4

Timing DiagramsTL/H/12387–13FIGURE 7a. Sync-Out Write (WMODEe1, BWe1), Read and Convert CyclesTL/H/12387–14FIGURE 7b. Sync-In Write (WMODEe1, BWe1), R

Pagina 5

Timing Diagrams (Continued)TL/H/12387–46FIGURE 7c. Sync-Out Write (WMODEe0, BWe1), Read and Convert CyclesTL/H/12387–47FIGURE 7d. Sync-In Write (WMODE

Pagina 6 - Notes on Specifications

Timing Diagrams (Continued)TL/H/12387–48FIGURE 7e. Sync-Out Read and Convert Cycles. The MUX channelis the channel selected on the most recent write c

Pagina 7 - Figure 6

Timing Diagrams (Continued)TL/H/12387–50FIGURE 7g. 8-Bit Bus Read Cycle (Sync-Out)TL/H/12387–51FIGURE 7h. 8-Bit Bus Read Cycle (Sync-In)15

Pagina 8 - Electrical Characteristics

Timing Diagrams (Continued)TL/H/12387–15FIGURE 7i. Write Signal Negates RDY (Writing the Standby, Auto-Cal or Auto-Zero Command)TL/H/12387–16FIGURE 7j

Pagina 9 - TL/H/12387–8

Typical Performance Characteristics (See Note 19, Electrical Characteristic Section)Integral Linearity Error (INL)Change vs Clock FrequencyTL/H/12387–

Pagina 10 - (Continued)

Typical Performance Characteristics (Continued) (See Note 21, Electrical Characteristic Section)Supply Currents vsClock FrequencyTL/H/12387–42Referenc

Pagina 11

Typical Performance Characteristics (Continued) The curves were obtained under the followingconditions. RSe50X,TAe25§C, VAaeVDae5V, VREFe4.096V, fCLKe

Pagina 12 - Timing Diagrams

Connection DiagramsPLCC PackageTL/H/12387–2Order Number ADC12048CIVSee NS Package Number V44APQFP PackageTL/H/12387–3Order Number ADC12048CIVFSee NS P

Pagina 13 - Timing Diagrams (Continued)

Pin DescriptionPLCC Pkg. PQFP Pkg.Pin Name DescriptionPin Number Pin Number6 44 CH0 The eight analog inputs to the Multiplexer. Active channels are se

Pagina 14

Register Bit DescriptionCONFIGURATION REGISTER (Write Only)This is a 13-bit write-only register that is used to program the functionality of the ADC12

Pagina 15

Functional DescriptionThe ADC12048 is programmed through a digital interfacethat supports an 8-bit or 16-bit data bus. The digital inter-face consists

Pagina 16

Features and Operating Modes (Continued)less than 1 kX and any active or reactive source circuitrysettles to 12 bits in less than 500 ns. When source

Pagina 17

Features and Operating Modes (Continued)conversion, two reads must be performed from theADC12048. The rising edge of the second read pulse willforce t

Pagina 18 - TL/H/12387–45

Analog Application InformationREFERENCE VOLTAGEThe ADC12048 has two reference inputs, VREFaandVREFb. They define the zero to full-scale range of the a

Pagina 19

Analog Application Information (Continued)INPUT CURRENTAt the start of the acquisition window (tAcqSYNOUT) a charg-ing current (due to capacitive swit

Pagina 20 - Figures 3

Analog Application Information (Continued)TL/H/12387–38FIGURE 10. Top View of Printed Circuit Board for a 44-Pin PLCC ADC12048When measuring AC input

Pagina 22 - Features and Operating Modes

Physical Dimensions inches (millimeters)44-Lead Molded Plastic Leaded Chip CarrierOrder Number ADC12048CIVNS Package Number V44A29

Pagina 23

Absolute Maximum Ratings (Notes 1 and 2)If Military/Aerospace specified devices are required,please contact the National Semiconductor SalesOffice/Dis

Pagina 24

ADC12048 12-Bit Plus Sign 216 kHz 8-Channel Sampling Analog-to-Digital ConverterPhysical Dimensions inches (millimeters) (Continued)44-Lead (10mm x 10

Pagina 25 - Figure 9

Power Supply Characteristics The following specifications apply to the ADC12048 for VAaeVDae5V,VREFae4.096V, VREFbe0.0V, 12-bitasign conversion mode,

Pagina 26 - Figure 10

Reference Inputs The following specifications apply to the ADC12048 for VAaeVDae5V, VREFae4.096V,VREFbe0.0V, 12-bitasign conversion mode, fCLKe12.0 MH

Pagina 27

Digital Timing Characteristics The following specifications apply to the ADC12048, 13-bit data bus width,VAaeVDae5V, fCLKe12 MHz, tfe3 ns and CLe50 pF

Pagina 28

Notes on Specifications (Continued)Note 6: Each input and output is protected by a nominal 6.5V breakdown voltage zener diode to GND; as shown below,

Pagina 29 - NS Package Number V44A

Electrical CharacteristicsTL/H/12387–5FIGURE 1. Output Digital Code vs the Operating Input Voltage Range (General Case)TL/H/12387–6FIGURE 2. Output Di

Pagina 30

Electrical Characteristics (Continued)TL/H/12387–7FIGURE 3. VREFOperating Range (General Case)TL/H/12387–8FIGURE 4. VREFOperating Range for VAe5V9

Comentarios a estos manuales

Sin comentarios