1.4. Powering Up the Board
The SBC35-A9G20 requires 5V DC (±5%). DC power is supplied to the board via J3.
Coaxial plug center positive standard.
1.5. Getting Started
The SBC35-A9G20 board is delivered with a pre-installed U-Boot boot loader and an
Embedded Linux operating system. These two components are stored in the NAND Flash.
You can update your board by downloading all the available sources and tools on the calao website
www.calao-systems.com in order to adapt your system to your needs.
Datasheet USG-00019-A01 6/24
Comentarios a estos manuales