Rainbow-electronics AT49F1025 Manual de usuario

1AT49F1025PLCC Top View78910111213141516173938373635343332313029I/O12I/O11I/O10I/O9I/O8GNDNCI/O7I/O6I/O5I/O4A13A12A11A10A9GNDNCA8A7A6A5654321444342414

10AT49F1024/10250765I–05/01Notes: 1. These parameters are characterized and not 100% tested.2. See tOE spec in “AC Read Characteristics” on page 6.Dat

11AT49F1024/10250765I–05/01Software Product Identification Entry(1)Software Product Identification Exit(1)Notes: 1. Data Format: I/O15 - I/O8 (Don’t C

12AT49F1024/10250765I–05/01Boot Block Lockout Enable Algorithm(1)Notes: 1. Data Format: I/O15 - I/O8 (Don’t Care); I/O7 - I/O0 (Hex). Address Format:

13AT49F1024/10250765I–05/01AT49F1024 Ordering InformationtACC(ns)ICC (mA)Ordering Code Package Operation RangeActive Standby35 50 0.1 AT49F1024-35VC 4

Packaging Information14AT49F1024/10250765I–05/01.045(1.14) X 45°PIN NO. 1IDENTIFY.045(1.14) X 30° - 45°.012(.305).008(.203).021(.533).013(.330).630(16

© Atmel Corporation 2001.Atmel Corporation makes no warranty for the use of its products, other than those expressly contained in the Company’s standa

2AT49F1024/10250765I–05/01read and programming operation of the device. Reading data out of the device is similarto reading from an EPROM. Reprogrammi

3AT49F1024/10250765I–05/01operation (please refer to the Command Definitions table). The device will automaticallygenerate the required internal progr

4AT49F1024/10250765I–05/01Notes: 1. The DATA FORMAT in each bus cycle is as follows: I/O15 - I/O8 (Don’t Care); I/O7 - I/O0 (Hex).The ADDRESS FORMAT i

5AT49F1024/10250765I–05/01Notes: 1. X can be VIL or VIH.2. Refer to AC programming waveforms.3. VH = 12.0V ± 0.5V.4. Manufacturer Code: 001FH, Device

6AT49F1024/10250765I–05/01AC Read Waveforms(1)(2)(3)(4)Notes: 1. CE may be delayed up to tACC - tCE after the address transition without impact on tAC

7AT49F1024/10250765I–05/01Input Test Waveforms and Measurement LeveltR, tF < 5 nsOutput Test LoadNote: 1. This parameter is characterized and is no

8AT49F1024/10250765I–05/01AC Word Load WaveformsWE ControlledCE ControlledAC Word Load CharacteristicsSymbol Parameter Min Max UnitstAS, tOESAddress,

9AT49F1024/10250765I–05/01Program Cycle WaveformsMain Memory or Chip Erase Cycle WaveformsNotes: 1. OE must be high only when WE and CE are both low.2